钢结构课程设计-24米跨厂房桁架设计(国外英文资料).docVIP

钢结构课程设计-24米跨厂房桁架设计(国外英文资料) directory 1, design data 1 The structure simplified figure 2 Load calculation 4 Four, inner forces calculate five 5, the shaft design 6 Node design 10 Design of steel structure course Design data The length of the workshop is 90m, and the vertical column is 6m. The frame span of the steel truss roof is 24m. The structure USES trapezoid. The frame adopts Q235B steel, the member chooses hot rolled Angle steel. The node is welded and the electrode is E43. The structure of the house is made of steel lines, and the plates are made of steel plates, and the load is: Roof and supporting value: Q = 0.12 + 0.011 L, which is the unit of m, and q is the unit of kN over m2 Roof laid pipe load standard value: 0.20 kN/m2 Roof value: 0.35 kN/m2 Roof live load standard value: 0.50 kN/m2 Ash load: 1.20 kN/m2 Two, structural form and supporting arrangement Draw the horizontal support and purline chart of the roofing roof The calculation of internal force, section dimensions of steel roof, and the most unfavorable combination of internal forces. Design a lower chord node, an upper chord node, a support node, a roof node, and a central node of the lower chord. Structure and support Truss support arrangement SC: the upper string supports; XC: lower string support; CC: vertical support GG: rigid frame; LG: flexible tie bar Load calculation Truss and roof The permanent load along the roof is multiplied by 1 / cosa = 1.006, which is the load that is distributed along the horizontal plane. Load standard The standard value of the permanent load calculated at the level of the roof Standard permanent load: The roof itself weighs 1.006 * 0.35 = 0.352 kN/m2 Pipe load 0.20 kN/m2 The roof and support itself weigh 0.120 + 0.011 x24 = 0.384 kN/m2 ___________ Its 0.936 kN/m2 Standard variable load: Roof load 0.50 kN/m2 The ash load is 1.20 kN/m2 ___________ 1.7 kN/m2 Consider the following three load combinations All across permanent loads plus all transvariable loads Full s