PM0502-03 船舶甲板、内底板、舱壁、围壁局部(国外英文资料).docVIP

PM0502-03 船舶甲板、内底板、舱壁、围壁局部(国外英文资料) Within the ship deck, bottom, bulkhead, wall local/cut in large area general process (rev. 5.0) PM0502-03 (4/4) The ships deck, inner bottom board, bulkhead, wall of enclosure and large area of mowing of the gm process plan Purpose 1. Control the main factors that affect the quality of the project and ensure the quality of the project. Process plan 2.1 prepares materials Request sheet for the chemical composition and mechanical properties of no less than the old material consistent with the old board, thickness in principle is not greater than the original design requirements of the new board not less than the original old plate thickness. Be applied to the shipowner/surveyor as necessary. 2.2 the old boards are cut 2.2.1 deck, inner bottom, bulkhead, large area of enclosed wall A. according to the technological requirements in installment, partial cut in, and take the corresponding strengthening measures, in order to prevent hull deformation and, when necessary, should obtain the recognition of the owner/surveyor. B. is connected with the plate frame, such as cutting in larger quantity is more, at the same time to cut the frame number is too much, should be in accordance with the principle of cutting two leave a process discontinuity mutilation, must add temporary support strengthen when necessary. The position definition and cutting notice of the slot is defined A: the cutting line of the cutting board should be as open as possible. The parallel distance between the seams should be no less than 100mm and should avoid intersecting. The distance between the plates and the adjacent plates and the adjacent plates shall not be less than 50mm. C. for non- ten or T , the Angle should be rounded. The arc radius is more than 10 times the thickness of the original plate and must be greater than 100mm. D. before cutting, a cut line should be drawn. Remove rust, oil and other dirt on both sides of the cutting line so as not to affect cuttin