原子吸收分析仪操作步骤(国外英文资料).docVIP

原子吸收分析仪操作步骤(国外英文资料) The atomic absorption analyzer operation procedure [view the users profile in the data center] [personal data] [message] [post collection] [citation] [citation] [maintenance] -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- The atomic absorption analyzer operation procedure (1) the complexity and variability of the substrate due to water solubility and solid waste must be dealt with before appropriate. The solids, sludge and aerosols must be dissolved before analysis, which varies depending on the metal and sample characteristics of the analysis. (2) all atomic absorption spectra must be performed with appropriate background correction. (3) due to different brand name and model of atomic absorption spectrometer will have differences, detailed instructions cannot be formatted to apply to each instrument, so the analyst when using instruments must follow the manufacturers instructions. The following should be noted for the operation: After selecting the proper lamp tube, you usually need to preheat the lamp tube for 15 minutes. 2. Available in the meantime, adjusting instruments, ChanGuangQi will be dispatched to the correct wavelength, select the appropriate ChanGuangQi slit width, and adjust current in accordance with manufacturers recommendations. Ignition and adjust the flow of fuel and oxidizer, adjust the flow rate of combustion head and spray, to achieve maximum absorption and stability, and maintain the balance of photometer. Measure a series of standard solutions for measuring elements, and draw absorbance to establish a check line. Take the sample solution and read it directly or measure its concentration by the measuring line. A standard solution must be measured at the same time per analysis of one or a series of samples. (4) production and verific