地下水防护办法(国外英文资料).docVIP

地下水防护措施(国外英文资料) Groundwater protection measures To prevent materials, waste, etc. Run, run, drip, leakage and seepage of groundwater pollution, special protective measures: take the following groundwater for three prevention engineering points, key, in general, the seepage control section respectively, specific as follows: (1) key impervious area focus on impervious area including galvanizing workshop, blue workshop, staging of hazardous waste, waste water treatment and accident pool area. The foundation must be made of clay, and the thickness must not be less than 100cm. The permeability coefficient of clay materials 10-7 cm/SEC or less, in can meet 100 cm thick clay foundation pad, under the condition of common clay cushion can use 30 cm thick, and placing the 2 mm thick, high density polyethylene or other artificial anti-seepage material at least 2 mm thick, the permeability coefficient of 10 or less - 10 cm/SEC. Key impervious area except for floor foundation seepage control measures taken by the further take the following measures: s hazardous waste collection pool between staging and accident using anti-seepage concrete + HDPE membrane (1.5 mm thick, coefficient of permeability is not higher than 1.0 x 10-11 cm/s of HDPE membrane as the impervious layer); (2) general seepage zone Generally impervious area including seepage core zone of the remaining parts of the ground, including raw material storage, shipping department, the permeability grade level is not lower than P1 impermeable concrete (permeability coefficient is about 0.4 x 10-7 cm/s, the thickness of not less than 20 cm) hardening the ground. The non-seepage area includes the green area of the factory, the office building, the canteen, etc., not taking the anti-infiltration measures. In addition, the following measures should be taken: (1) to implement detailed plans for clean production and recycling of all kinds of wastes, and reduce the amount of pollutants discharged; To prevent leakage of pollut