水轮机检修与维护(国外英文资料).docVIP

水轮机检修与维护(国外英文资料) Procedures for maintenance and maintenance of water turbines Q/MXSD10301.1-2006 Subject matter and scope of application The basic parameters, structure, maintenance contents and fault handling of the hydraulic turbine of the isthmus station are provided by this standard. The standard is applicable to the maintenance and maintenance of the mechanical personnel of the site of isthanyang power station. The following personnel shall be familiar with this procedure The leading personnel: the production assistant general, the production department manager (director), the deputy manager (assistant director, the assistant manager), the full-time technical personnel. 1.3.2 manufacturing personnel: the operator, the operator, and the maintenance staff. Introduction of hydraulic turbine structure The rotor room is assembled The rotating chamber assembly includes the revolving room, the foundation ring, and the expansion section. Room 2.1.1 Wheel chamber for steel plate welded structure, the upper within the scope of the blade Angle 90 ° easy cavitation area of stainless steel, with blade surface is spherical, throat Φ 5277 mm diameter, for ease of installation, upper and lower two and a half, with bolt together, using Φ article 14 rubber seal. The runner chamber with the bolt and the efferent water ring together, the legal seal USES Φ 16 article rubber seal. 2.1.2 base ring The base ring has the expansion section, and the rear is welded to the stern pipe, it is the foundation of the expansion section, the revolving room and the seat ring has certain coaxial degree and the parallel degree requirement. The base ring adopts the steel plate welding structure, and after the adjusting axis of the installation, the downstream end and the stern tube are lined up. The basic ring should be able to withstand the hydraulic vibration from the wheel chamber, so the requirement is strong with the concrete. Expansion section Installed on the wheel slip joint between the chamb