基于RFFD多通道变形的产品造型设计方法.pdfVIP

November 2013 机械科学与技术 2013 年 11 月 Mechanícal Science and Technology for Aerospace Engineering Vol. 32 No. 11 第 32 卷第11 期 基于 RFFD 多通道变形的产晶造型设计方法 郭磊l 气吉晓民1 ，胡钢l ，初建杰3 h ( I 西安理工大学，西安 71C刷8;2 电子科技大学中山学院，中山 528402; 3西北工业大学，西安 71∞72) 郭磊 摘 要:提出由设计师提供具有多个变形通道的产品初始造型方案，具体的造型细节支由用户在可 局部变形的模型上直接调整，结合用户调整的数据反馈信息，通过统计分析获得最终所需产品造型 方案的设计方法。该方法应用的过程中，用户直接在进行产品评价的同时进行了造型方案的再设 计，使用户表达了对产品造型的个人期望，又使设计师获得多个用户对产品造型期望的直接数据。 该方法将产品造型评价环节和设计环节结合在一起，可改善设计与评价之间的沟通，从而提高产品 造型设计效率。 关键词:造型设计;变形;变形通道;RFFD 中图分类号:TP391 文献标识码:A 文章编号:1∞3-8728(2013) 11-1633.Q5 Designing Product Form Based 00 RFFD and Multi-channel Deformatioo Guo Lei 1,2 , Ji Xiaomin 1 , Hu Gang 1 , Chu Jia叮ie3 CXian University of Technology , Xian ， 71C削; 2 University of Elec田nic and Technol吻。f Chína , Zhongshan Institute , Zhongshan 52归02; )Northwestem Polytechnical University , Xi an 71∞72) Abs衍act : A product fonn design me由odb副ed on RFFD multi-channel defonnation is proposed. FirsÙy , the de- signer provides an initial conceptual product form scheme with multi-channel deformation. Then the detailed prod- uct fonn is modified by its u回r according to a 1时ally changeable mode l. Finally the designer detennines the final product fonn through statistic analysis of the feedbacks from 由eu盹r. In this process , the redesi伊 and evaluation of 由e product fonn 缸e carried out simultaneously. As a result ，由is method can not only enable the u回r to express his or her personal expectation of the product fonn but also enable the d四ignerωobtain direcùy the data of the product fonn as expected by