门机XY-3W7微电脑力矩限制器应用仿单（国外英文资料）.doc

门机XY-3W7微电脑力矩限制器使用说明书（国外英文资料） No dust, corrosive gas, combustible gas, avoiding drips and salty environment. The main instrument power supply is separate line, not in the same phase as other lighting and power. The weight sensor and Angle sensor are separately worn in the line, and do not interfere with the cable and other cable. - 3 - XY - 3W7 microcomputer torque limited control system usage specification Eight. System debugging Electricity: connect all cables, confirm correctly, connect 220V power supply. Calibrate the debug step: Function code table F00 weight sensor A zero F04 weight sensor A calibration F01 weight sensor B zero F05 weight sensor B calibration F02 calibration arm frame small Angle point F06 frame large Angle point (1) open the main box cover and turn the two switches ON the main plate to ON. The rest is done on the display panel. (2) enter the password: cancel Bring about confirm Set up the Click (right window display 018) (3) small Angle points for the arm frame: The crane is placed at the largest point (the minimum Angle point of the arm frame). Bring about confirm Bring about ▼ Set up the Click (left window display F02) or cancel confirm (the right window shows the value to the actual Angle) (4) the height Angle of the arm frame: the crane is at the minimum (the maximum Angle of the arm frame). ▼ Set up the ▼ confirm Bring about Click in turn (left window shows F06) or cancel confirm (the right window shows the value to the actual Angle) (5) the empty hook to the skin (zero) : The crane lifted the hook Bring about Confirm (2 times) ▼ Set up the In turn by (left window shows F00) (left window shows F01) Confirm (2 times) cancel (6) load calibration: Cranes lift up to 70 percent of the load weight Calibrated weight sensor A: Bring about confirm ▼ Bring about Set up the In turn according to the (left window shows F04) or (right window display values confirm 1/2 for the value of a given weight - 4 - XY - 3W7 microcomputer torque limited control