GLLA01B;GLLA01A1B;GLLA01A1Y;GLLA01A2Y;GLLA01C;中文规格书,Datasheet资料.pdfVIP

ISSUE 3 Installation Instructions for the GLL Series Limit Switch WARNING POSITIONING LEVER The lever on rotary actuated units is adjustable to any of PERSONAL INJURY the segmented positions 360° around the shaft; • Where possible, install these switches with the however, the degree of rotation is dependant on head conduit opening pointed down to drain moisture away position and direction of roller. from switch. 1. Loosen the lever retaining screw with a Phillips head • Do not install switch at the low point of a conduit run. screwdriver. • Install a fitting into the conduit opening that provides 2. Remove lever. strain relief to the wires/cable, as well as sealing 3. Reposition lever to desired location. against contaminants found in the application. 4. Securely tighten screw. • In applications where fluids or moisture may be present, seal the fitting threads with a product such REVERSING THE ROLLER LEVER as Teflon tape or pipe dope. The roller arm may be reversed to face the roller to the Failure to comply with these instructions could result in inside or outside of the arm. death or serious injury. ADJUSTABLE LENGTH LEVERS GENERAL INFORMATION