双通带滤波器的设计.PDFVIP

双通带滤波器的设计 金 洋 摘 要：随着无线通信技术的飞跃发展，如今同时工作在两个或多个频段的通信系统成为了其重要的研究方向，而本文主要提 供的是双通带滤波器的研究。我们知道，双通带滤波器的研制有很多种方法，可以将一个带通滤波器和一个带阻滤波器串联从 而制成，而本次我设计的方法则是用的两个带通滤波器并联实现的双通带滤波器，故而我将从设计单通带滤波器的原理进行阐 [1] 述。本文简单的介绍了滤波器的基本理论和设计原理，包括切比雪夫型滤波器低通原型 ，由低通原型设计带通滤波器的频率 变换方法和过程，J 、K 变换等实现阻抗变换，利于用微带线实现实际的电路结构。最后使用 HFSS 软件，确定尺寸并且创建 模型。最后设计出了一款中心工作频率分别为2.4GHZ 和 3.8GHZ，各自-1dB 带宽为 140MHz 和 90MHz 。在带内的回波损耗 低于-15dB，插入损耗小于-2dB 的双通带滤波器，满足WiFi/Wlan 运用。 关键字：频率变换；双通带滤波器；微带线 Abstract ：With the rapid development of communication technology,today,while working in two or more bands of communication systems has.become an important research direction,and this paper is to study the offer dual-band filter.We know that the development of dual-band filters,There are many ways ,a band-pass filter and a band-stop filter can be connected in series and thus made,but this way I designed it with two pass-band filter in parallel to achieve dual-band filter,and therefore I will elaborate design principles single pass-band filter.This paper briefly introduces the basic theory and design principles of the filter,including the -low-pass filter prototype by frequency conversion method and process low-pass prototype band-pass filter,J.K transform to achieve impedance transformation,conducive to the actual circuit configuration using the micro-strip line.Finally,use HFSS software and create a model to determine the size.Finally devised a center frequency and were 2.4GHZ/3.8GHZ ,each -1dB.140MHZ bandwidth and 90MHZ.Return loss is less than the band -15dB,insertion loss is less than the dual-pass-band filter -2dB meet WIFI/WLAN use. Key words: frequency conversion; dual-band filter; micro-strip line; 1. 引言 无线通信技术的飞速发展，给人们的生活带来了很大