最新风电场运维人员技能考试试卷（国外英文资料）.docVIP

最新风电场运维人员技能考试试卷（国外英文资料） In 2012, wind farm operators Skills exam paper (theoretical section) 1, fill in the blanks (30 minutes, 0.5 points, 15 points) The frequency converter is classified according to the mode of the main circuit, which can be divided into voltage frequency converter and current frequency converter. The engine room can rotate in two directions, and the direction of rotation is detected by the near switch. When the cabin yaw limits of turns in the same direction, the limit switch will signal to control device, control unit down quickly, and the reverse solution of spring. The preventive maintenance of wind power units in accordance with the maintenance schedule provided by the manufacturer strictly is scheduled maintenance. 4. The frequency of the power system running is controlled by active system, the voltage is controlled by reactive system. 5. PT100 sensor resistance value and temperature conversion: on the relationship between resistance value for 100 Ω temperature 0 ℃. The work ticket should be in duplicate, one should be kept at the work place by the work person and the other by the work permit. 7. If the wind speed exceeds a limit value, such as 5 or 10 minutes average (average wind speed), the average 5 seconds (wind speed) must immediately stop working. No maintenance or repair work shall be performed. The blade is located in any position between position and the position of the paddle. The data point of wind field measuring tower is located at the height of the fan hub, which should contain wind speed, wind direction, temperature, pressure and so on. Increasing the tower height of the generator set can reduce the impact of turbulence intensity. The insulation grade of a generator for wind turbines is usually given an F. The zero sequence voltage of the ground fault point is the highest, the lower the voltage is as the distance from the fault point is further away. The power curve of a wind generator is a function of the power output of th