若何设置BIOS,提高开机速度（国外英文资料）.docVIP

如何设置BIOS,提高开机速度（国外英文资料） One. Optimize startup speed Every time you start a computer you have to wait a long time to get into the system. How do you get to the system faster? The following USES the BIOS method to optimize startup speed. How to turn on the quick start self-checking function After start the computer, the system of self-examination procedures, this process is known as POST - plus electricity self-inspection (Power On Self Test), to Test the system almost all of the hardware. Follow these steps to speed up self-checking and speed up the startup. Step 1 start the computer, press the Del key, and enter the BIOS to set the main screen. Step 2 selects the Advanced BIOS Features (Advanced BIOS Settings feature) to set the entry and press Enter. Step 3 move the cursor to the Quick Power On Self Test item, set to Enabled. If you choose Disabled, the computer will perform the boot self-check at regular speed, three times in memory. Step 4 return the main interface by pressing the Esc key, move the cursor to Save exit Setup (store and end Settings), and Save the Exit by pressing the Y key. How to turn off the boot-checking function Step 1 opens the Boot Up Floppy Seek (Boot Floppy detection) feature that will allow the system to detect the 1.44 MB Floppy drive at Boot time, which causes a delay of about 1 to 2 seconds. To speed up the startup, you can close this feature. Step 2 start the computer and press the Del key to enter the BIOS to set the main screen. Step 3 sets Boot Up Floppy Seek for Disabled to turn off Boot Floppy drive detection. How to set the hard disk to the first start In the BIOS, you can select the floppy disk, hard disk, CD, U disk, etc. But in general, it starts with a hard drive. You can set the first boot disk in the BIOS Settings to speed up the boot. Step 1 start the computer and press the Del key to enter the BIOS to set the main screen. Step 2 select the Advanced BIOS Features setting entry to Enter. Step 3 sets the First Boot Device