ERP电子商务管理系统doc.doc

ERP电子商务管理系统 入库 采购管理-----采购入库单-----来货（销售单）-----直营-----点来源单号-----采购订单-----商品明细-----根据条码找货-----核对数量-----修改数量-----删除无货单项-----确认入库数-----打印条码----贴条码-----上架-----入库后报表管理-----打印 损品出库 库存管理-----库存调整单-----新增-----库存调整类型-----货物损坏----选择仓库（成品仓：直营）（成品市场部：市场部）（虚拟仓：全部都是损品及问题单）（包材仓：共享）（水晶仓：共享）-----条码扫描-----输入负数的数量-----确定 打单 进入管易伴侣----物流批次管理----物流批次管理表-----非活动款----刷新后生成物流批次（订单数与未生成数一致）-----生成新的批次（查看）-----生成小批次（加急/个性：其他）（加急/个性：申通）（普通：其他）（普通：申通）-----复制物流批次号-----打开ERP软件-----订单管理----发货单-----选择日期（一周前至今）-----粘贴物流批次号（在买家备注“%”的后面）-----全选-----打印物流单-----选择打印机-----打印-----第一份快递单号扫描-----自动生成快递单号----保存-----打印发货单-----打印-----对应快递单发货单订一起-----大头笔 配货 清点发货单-----根据发货单找货-----放入筐中-----拿去扫描 质检 订单管理-----扫描出库----输入配货员代码-----回车-----扫描物流单号----扫描条形码-----通过后按F12-----进入发货单-----扫描物流单号-----自动发货 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports