S700K(国外英语资料).doc

S700K(国外英语资料) S700k speed increasing type electric switch machine I. features: 1 、 AC three-phase motor. From the fundamental solution to the original DC electric switch machine must set the commutator caused by the failure rate. 2. The ball screw with diameter of 32MM is adopted as driving device. 3, the use of spring type extrusion device of the retaining connector, and the use of non extrusion parts, fundamentally solve the squeeze pin due to the old damage caused by the inertia of the fault. 4, using a multi chip dry adjustable friction connector, by adjusting the use of factory sealed, no need to adjust. 5. The switch locking adopts external locking device. Brief introduction of main components and functions of two and S700k electric switch machines: 1, the three-phase AC motor, 2 gear sets 3, 4, 5 ball screw friction connector, 6 connector, keep the detecting rod (said rod) 7, the locking block and the lock tongue, 8 speed switch (automatic shutter) 9, shutoff switch and lock (1) the three-phase AC motor: three windings of three-phase AC motor with star connection method, each phase lead wire are single stranded wire, a star collection point connected to the wiring seat, B12, C12 A12, (sand and terborg contact is assembled on the safety contact seat sixty-first, seventy-first, eighty-first). (2): gear gear set consisting of crank gear, motor gear, intermediate gear and a friction gear connector. The crank gear and a motor gear transmission system, its function is to use the hand crank for manual operation of electric switch machine. Motor gear, intermediate gear and a friction gear is a transmission device, the main role is to slow down high-speed rotating motor, the rotary driving force increases, in order to meet the needs of switch, is the first level switch machine reducer. (3) friction connector: its main function is to transfer the rotational force of the variable gear set to the ball screw after it is changed. When used as a ball screw, the transition r