核辐射探测习题解答3(国外英语资料).docVIP

核辐射探测习题解答3(国外英语资料) This article is contributed by bright_chou DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The third chapter homework answer 1. in Figure 3.6 nomograms, calculate the bias of 0.1mm produced by N type silicon with 1000 ohm *CM resistivity of a semiconductor junction detector in thick depletion depth needed. Solution: P161, figure 3.6, 0.1mm=100um, connect the two points of the resistivity and the sensitive area thickness, and extend the line bias voltage at the point corresponding to the 35V. The bias voltage is 35V. 3. when the alpha particle is collimated perpendicularly to the surface of the gold silicon barrier detector, the 0 alpha peak of the Am scale source is located at the 461 channel of the multichannel analyzer. Then change the geometric conditions, the alpha particles deviate from the normal incidence angle of 35 to 449, at this time, peak displacement, die thickness test (alpha particle energy loss). Solution: P162 material when the alpha particle vertical incident energy loss of E0 when theta = 0, alpha particle is set in the detector dead layer within the energy? E1 detector volume obtained energy (E0-? E1) alpha peaks in 461 and 12 when theta = 350, the death of energy loss layer? E2 = E1 = 55 = 1.22? 0.22 detector sensitive volume obtained energy (E0-? E2) = E0-1.22? E1 alpha peaks of two point 449 is the alpha particle detector incident sensitive volume were obtained for the energy difference? E = 461 - 449 = (E0-? E1) - (E0-? E2) = 12 E0 E1-? E0+1.22? E1=0.22? E1 12 so? E1 = = 55 (Road) 0.22 (supplement: by manual, the main alpha ray energy of the Am scale source is E = 5.485 MeV, set G per channel Two hundred and forty-one Two hundred and forty-one The energy that should be, then Solvable 461 x G = E = E1 = 5.485, E1 = 449 * G = E = E = 2 = 5.485 = 1.220 = E1 = E1 = 0.580MeV) 4. test the expected differential pulse amplitude