狗管的技术条件(国外英语资料).docVIP

狗管的技术条件(国外英语资料) First, the characteristics of the dog tube and the main technical conditions Dog tube is a very important part of the dog, its quality is not only related to dog shooting accuracy and service life, but also directly affect the dog steady, accurate and ruthless to destroy the enemy. Therefore, before machining, it is necessary to analyze and understand the characteristics of the dogs tube and its connection with other parts, and be familiar with its main technical requirements. What are the characteristics and requirements of dog tubes? Dog tube is a slender and long, the size of the bore, precision and smoothness requirements of high, special process more typical parts. It consists of line chamber, chamber, the outer circle of the. The outline of the dog tube is shown in figure 3-1-1. (1) the bore part; The inner surface rifling carved with four right-handed twist 240 mm in the trough, it is called Yin rifling, when the projectile by Huo medicine gas pressure to advance, can obtain the direction of flight stability in the air. The ribs between yin and Yin called line. The two sides of the line in the rotation of the projectile side called the leading side turn. The center line of line and line should be concentric, the line twist can not be too small or too large. After hours, the line by bullet wear is large, and reduce the side guide line to make the projectile prematurely leave the line; gap is too large, the bottom line increases, gas into the gap increased, thereby reducing the dog mouth kinetic energy and velocity of projectile flight stability and range. The variation of the sectional area of the dogs pipeline cannot be too large, otherwise the continuity of the bullet. Line and line is not allowed to have significant wave pattern, in order to ensure the stability and the normal rotation of the projectile motion in the bore, affect the stability of ballistic performance. The line is not allowed to have the rotary side corner of bilateral and