调节阀维护检修规程(国外英语资料).docVIP

调节阀维护检修规程(国外英语资料) 1 Purpose In order to strengthen the maintenance and maintenance of control valve quality, so that the control valve can long life, stability, to achieve the role of regulation, the development of these procedures. 2 scope of application Applicable to the companys automatic control of the production process, pneumatic actuator and valve body composed of pneumatic control valve, including the general single seat valve, two seat valve, sleeve valve, such as maintenance, maintenance, maintenance. 3, the concept of control valve The regulating valve is the terminal adjustment instrument in the automatic control system. It is installed on the process pipeline, adjust the flow rate and pressure of the modulated medium, and control the process parameters according to the set requirements. Direct contact with high temperature and high pressure valve, cryogenic, strong corrosion, high viscosity, easy to crystallize, toxic and other coking process media, which is the most vulnerable to corrosion, erosion, cavitation, aging, damage to the instrument, often lead to difficulties in the control of production process. Therefore, attention must be paid to the operation, maintenance and overhaul of the regulating valve. 4 operation and maintenance 4.1 control valve operation 4.1.1 control valve in the system is put into operation to do joint. 4.1.2 control valve in the work, before and after the shut-off valve should be fully open, the bypass valve (side line valve) should be closed. The whole pipeline system in other valves should be opened as large as possible, usually regulating valve should be in the normal use of range (20% - 80%) work. 4.1.3 use handwheel control valve, should pay attention to hand wheel position indication mark. The position of the valve stem and the compression spring is strictly prohibited during the operation of the 4.1.4 control valve. 4.2 daily inspection 4.2.1 patrol should check the control valve of the air pressure is normal, gas pat