受话、送话和振铃电路故障分析与维修(国外英文资料).docVIP

受话、送话和振铃电路故障分析与维修(国外英文资料) Analysis and maintenance of speech, delivery and ringing circuit March 19, 2007, 11:30 Analysis and maintenance of speech, delivery and ringing circuit The maintenance of a speech circuit Receiver circuit fault is mainly to hear each other voice, maintenance and repair, first used the oscilloscope measurement receiver contact waveform (dial 112), when we have vp 2-3 - p waveform, the receiver, bad change. If there is no waveform, then the audio decoding circuit and CPU are checked further. It is indicated that the class circuit is not good if there is no output signal. According to the maintenance experience, this failure is caused by the damaged or poor contact of the receiver. The receiver should be able to make simple judgments using the multimeter. Normally the receiver has a dc resistance, and the resistance is usually in dozens of euros, and if the dc resistance becomes significantly smaller or large, the receiver should be replaced. In addition, software failures can also cause phone failure. If the noise is loud, most of the speech is either defective or damaged by the receiver. Model: nokia 5110 Failure: when making a phone call, the caller cant hear the other persons voice. Analysis and maintenance: the fault must be from the antenna to a certain part of the listening channel. Generally such failures originate from logic/audio parts, are mostly poor contact the receiver and circuit boards, component virtual welding, open circuit, meet jack poor contact, such as audio processing chip damage caused. After the machine is removed, the receiver and the circuit connection are normal, may be the audio processing chip 5 feet, 6 foot virtual welding, the welding audio processing chip of 5, 6 feet, the failure to rule out. If the fault still exists, the audio processing chip measuring five feet, six feet on both ends of the positive and negative to the resistance, and both ends of the positive and negative to resistance, under normal circu