SPE 122783-MS中文翻译（国外英文资料）.doc

SPE 122783-MS中文翻译（国外英文资料） Hydrocarbon gases spread in heavy oil and asphalt The paper was prepared for the SPE Latin America and Caribbean petroleum engineering conference in cartagena, Colombia, from May 31 to June 3, 2009. The paper is a copy of the paper selected by the petroleum engineer society planning committee and the information contained in the review. The contents of the paper have not been reviewed by the petroleum engineering association, nor have they been modified by the authors. The material does not represent any views of the petroleum engineering association or its officials or members. It is forbidden to electronically copy, distribute, and store any part of the paper without the petroleum engineering associations written consent. Published papers are also limited to a copy of no more than 300 words in the abstract, and illustrations are not allowed to replicate. This summary must be clearly marked by the SPE. In this paper, The gas hydrocarbon solvent is used more and more in heavy oil recovery, because in some recycling conditions, the gas hydrocarbon solvent has many advantages over the heating method. In the process of recovery, the injection of an easily mixed solvent means a mass transfer process that is affected by the diffusion coefficient. Therefore, the measurement of diffusivity is very important. However, such words pose a huge challenge to experiment and data analysis. Although the diffusion coefficient is important, the diffusion coefficient of the vapor-liquid that is understood and calculated is not very significant. In a recent study, guerrero Aconcha Kantzas (2008) used slope and intercept analysis techniques to successfully obtain the diffusion coefficient of the heavy oil of liquid hydrocarbons. However, the technique involves the knowledge of prior composition concentration. There is a non-iterative, finite volume method that can obtain the diffusion coefficient without the need for concentration density. Computed auxiliary to