故障现象（国外英文资料）.doc

故障现象（国外英文资料） CS: the chip selection signal, which indicates that the BIOS chip is selected for the low level, the BIOS chip will work, and the high level indicates that the BIOS chip is not selected. WE: read and write allow the signal, high level indicates read operation, low level indicates write operation. Turn on the constant high level of high level for the POST and the self-check. OE: the data allows the output signal, which means that the BIOS chip allows the output of the data to be sent out and the output is not allowed. When these levels are in line, the BIOS is already working, so we can intuitively determine if the BIOS is working 1. Model: HP530 Failure: turn on not show To solve the process: The customer brought it in and said it didnt show up. Im using a adjustable point, and I find that the current is at 0.45 Experience seems to be a CPU that doesnt work. After disassembling the machine, it was discovered that it was the north bridge of the integrated graphics card 945GME. Add electricity and touch the CPU to find it is not very hot The voltage in the multimeter CPU is already out, and the other voltage is already being tested, considering whether the CPU is broken and the CPU is 945 And if you click on it, the current is still going to be 0.45, so its not a CPU problem. The north bridge was blown by the wind gun again, and there was no reaction Its still at 0.45. Use the network to borrow a force, find a circle on the net, still have experienced this kind of trouble before, the electric current to 0.45 wont move The teachers on the net have done the north bridge, the south bridge, the memory, the CPU is not good, looks bad repair. So Im going to be quiet, and Im going to test the signal again, and the CPU is reset The power signal, the bus voltage, the reference voltage, the core voltage, and the false load, test the address line and the data line of the north bridge to the CPU All right now. To see if the north bridge is flit, BGA, plus the north b