RS232中RTS和CTS的作用（国外英文资料）.docVIP

RS232中RTS和CTS的作用（国外英文资料） Q: It used to be clear that the previous understanding was wrong, and which of the following three explanations? Explain: RTS: Im ready for the terminal, and the data will come CTS: here we go Explain two: RTS: Im ready to send you the data, ready for the CTS response? CTS: okay, come on Explain the three: CTS: host, I have data, request receive RTS: I am the host, ready, request to send. Today I got a SIM100 module, after I set the RTS is invalid, of data to be sent to the host who didnt send me (including active data RING), instructions and return the result did not return, are cached in the module, after I set the RTS effectively, all cached data sent, including a lot of instruction execution result, thus, I think the above explain should be correct, and 2 should be wrong, but three is correct? So which of the CTS and RTS is the originator? A: Is a wrong Second, the RS232 standard Third, MODEM hardware flow control SIMCOMs explanation is absolutely right Long, long ago, there is no computer, at that time was already exists (computer) prehistoric serial device (teletype machine, the measuring equipment, industrial automation communication modems), in order to connect the serial port, the EIA formulated the RS232 standard, USES the DB25 connector, supports synchronous and asynchronous serial port, type D interface can effectively prevent the reverse. Standardization has brought convenience to use. Time flies, the personal computer, the existing serial interface devices undoubtedly became the first peripherals, naturally RS232 standard adopted by personal computer. But device manufacturers tend to have smaller, lower-cost interfaces, so they remove the unused and supported synchronization mode from DB25 and form DB9. The initial situation is quite confusing because DB9 only defines the signal, but does not specify the corresponding relationship between the signal and the pins, and the individual manufacturers can only define themselves. For