喷绘机常见故障（国外英文资料）.doc

喷绘机常见故障（国外英文资料） Problem 1, the jet drag is jiggled while painting, and the noise is made when printing. The image. Solution: 1, Y motor position is incorrect, Y motor belt is too loose, adjustable Y-axis motor position and belt tightening. Add a proper amount of oil to the guideway. Adjust the white roller height after adjusting the spray car. Damage to motor and motor accessories. Flush the shower head. Problem 2, the spray car has a sudden stop phenomenon. Solution: The belt of the spray-on is loose, adjustable pressure roller and the y-shaft motor and the belt of the spray belt are loose. The printing speed is too fast, the Y-axis is usually 3. Version 3. Problem 3, break ink in the painting process. (the nozzle is blocked, the suction is open, the blow is blocked for a while, and the picture has stripes. Solution: The air filter will be removed by the removal of the ink canisters and the ink can and the can of the ink pot. 2, below are the more ink (environmental and discomfort and temperature), high temperature too low, keep constant temperature 16-27 degrees or so, humidity is not too big, had better install fan. 3, the printing speed is too fast, 2 ~ 3PASS the speed of the Y-axis is 2, 4-2pass, which is faster, can be adjusted to 4. Check whether the power panel 35V is too high, adjust the voltage to below 35V. The ink problem. Flush the shower head. Problem 4, when printing, left and right, blurred image. Solution: The grating has dirt or damage and clean grating. Adjust the two-way compensation. The grid calibration is incorrect. Adjust the sprinkler height. Problem 5, the cleaning can not be done when printing. Solution: reset the cleaning position. Problem 6, the ink pump works, but the ink cant be punched in ink cans. Solution: Check for air or litter in the pipe between the large ink tank and the ink pump. If there is a fossa, the line will be straightened. Check the import and export of the pump. If the plug is plugged with syringe, it will be injecte