宽带拨号错误代码大全（国外英文资料）.doc

宽带拨号错误代码大全（国外英文资料） Wide-band dial-up error code Dial-up errors usually have a number error when the user declares a broadband failure. Usually, 6 errors are generally start with communication between the server has a problem, unless it is 691/619 This is the account problem, 7 errors are generally card problem in the beginning, especially the 769 error, is a network adapter is disabled. If there is another 7 start error. You can check the status of the network card and whether the protocol is complete Error 630: The port was disconnected due to hardware failure. (dont start WinPPPoverEthernet Service with this error, should start WinPPPoverEthernet Service to make the dial normal, right under the WINDOWS operating system started the lower right corner to see screen after the component has a dialer logo) Error 691: Access denied because username and/or password is invalid on the domain. (account password error, or debit downtime) Error 633: The port is already in use or is not configured for Remote Access dial out. (nic driver error, ready to network card drivers, and dial-up software, first uninstall dial-up software, TCP/IP, network card QuCheng; QuCheng again after restart the computer to install the network card, TCP/IP protocol and dial-up software. Need to ensure that there are WINDOWS system tray before unloading, nic QuCheng and the dial-up software) Error 645: Internal authentication Error. (dial-up network adapter error, ready dial-up software and WINDOWS system disk, uninstall dial-up software and dial-up network adapter) There is no error message indicating that the connection is being made. (Internet cable may be poor contact, observe whether card light is normally on, the light not bright if the network card, should check the cable and adapter. If the light is normal, can try to reinstall the dial-up software. Need to ensure that there are WINDOWS system tray before unloading, nic QuCheng and the dial-up software) Error: 678, no reply to the incoming c