模拟地与数字地隔离问题（国外英文资料）.docVIP

模拟地与数字地隔离问题（国外英文资料） The isolation of digital land and simulation The frequency of the digital circuit is high, the sensitivity of the analog circuit is strong, and the signal line is as far away from the signal as possible The sense of the circuit device, the whole PCB has only one node in the outside world, so it must be inside the PCB The problem of rational Numbers and the common ground, and the Numbers in the board and the analogs are actually separated from each other, only A connection between the PCB and the external connection (such as a plug). There is a little short answer to the analog, note that there is only one Join points. There is also a non-concomely on PCB, which is determined by the design of the system. However, when making PCB boards, they usually do copper Line, and the walking line is linked to GND, excuse me, can you tell the difference between the simulated ground and the number after the copper is laid out Does that mean that there is only one join point? Two different names, respectively copper, can be connected by a 10uH inductance or a 0 ohm resistor. The analog part of the device is concentrated in the vicinity of the other boards, reducing the attenuation of the signal. It doesnt matter that part of the line is long. Apply the copper to the simulation first, then apply the whole panel. simulation The ground and the digital ground will be automatically separated, using a 1uH inductance or 0 o resistance as a common site. 2 In the design of electronic system, in order to reduce the detour and save time, should fully consider and satisfy the requirement of anti-interference, avoid in The design is completed and then the remedial measures for anti-interference are carried out. There are three basic elements of interference: (1) the source of a disturbance means a component, device or signal that produces a disturbance, which is described in the mathematical language as follows: du/dt, di/dt Its the source of the disturbance. Lightning, re