理光打印机维修代码（国外英文资料）.docVIP

理光打印机维修代码（国外英文资料） One: SP maintenance mode Into the way: the C 107 CV key press more than 3 seconds, enter 1, copy, and then press the required Numbers into the way of maintenance, exit according to the yellow one copy of the C key to get into the normal way SP1 (feed model) 001: the head edge of the head [-9.0-9.0/0.1 MM/stage] [1] carton delivers paper, [2], paper, [3], and paper Alignment around 002:9.0/0.1-9.0 - MM/level the first paper [1] [2] the second paper [3] the third paper [4] the fourth paper [5] hand to send paper plates [6] double-sided 003: paper timing, regulating the bending of the paper. [1] first carton delivers paper (0-10/5/1 MM/level) [2] no. 2, 3, 4 [0-10/5/1 MM/level] [3] hand delivers paper [0-10/5/1 MM/stage] [4] double / 0-20/6/1 MM/level] 007: the display of the paper size 103: the shadow is running in the empty space. 105: fuser temperature control [1] standby [160 - grade 1 degree / / 190/175] [2] power saving level 2 0-100/60/1 / level 106: the fixing temperature is shown 107: fixing the adjustment of the soft start [1] standby [0 = 3 cycles / 1/2 = = 10 cycle 20 cycle [2] standby [0 = 3 cycles / 1/2 = = 10 cycle 20 cycles 108: the adjustment of the fixing soft start [0 = 1 second / 1 = 3 seconds] 109: check for the shadow zoned [0 = stop / 1 = start] 902: AC frequency shows 903: paper clutch on [1] hand again send carton [0-10/6/1 MM/level] [2] 1, 2, 3 cartons 0-10/3/1 MM/level 908: paper plates to adjust, adjust the up and down the carton of ascension reversal time optional 1 of [1] [2 - + 2/0/1 / level] [2] 2 optional [- 2 - + 2/0/1 / level) SP2 (drum units) 001: the bias of the charging roller adjusted [1] during printing [- level 2100-1500 / - 1700/1 v /] [2] ID sensor graphics [0-1 - / - 400/300 grade v /] 101: remove the adjustment of the boundary [1] head edge [0] - 9/3/0.1 MM/level [2] trailing edges [0-9/4 gives / 0.1 MM/level] [3] to the left edge of [0] - 9/2/0.1 MM/level [4] on the right side of the edge [0] - 9/2/0.1 MM