电脑开不了机排除故障（国外英文资料）.docVIP

电脑开不了机排除故障（国外英文资料） The computer is turned on without a display fault (see if there is any capacity for the drum). Step 1: first check if the external connection of the computer is connected, replant the various lines and see if the fault is ruled out. Step 2: if the failure remains, then open the main box to check the presence of excess metal inside the case, or the main deformation caused by short circuit, a plane in the presence of burnt smell the smell of burnt food, motherboard have burned chip, CPU around the capacitance is damaged, etc. Step 3: if not, then dust the board and check if the computer is normal. Step 4: if the fault persists, then remove the Reset line from the main board and other switches, indicator lights, and then switch to a screwdriver to see if it can be turned on. Step 5: if you cant boot, and then by using the method of minimum system of cable will hard disk, floppy disk, cd-rom, then check that the computer can boot, if there any boot screen computer display shows problems in these devices. Then one by one, the above several devices connected to the computer, when access to a certain equipment, fault occurs, that failure is caused by the equipment, and then focus on check this equipment. Step 6: if the failure persists, the failure may be caused by memory, graphics, CPU, motherboard, etc. Then use the method of interpolation and exchange to check whether the memory, video card, CPU and other equipment are normal, and if there is any damaged equipment, replace the damaged equipment. Step 7: if the memory, video card, CPU and other equipment to normal, then the BIOS discharge, the isolation method, put the main board on the outside of the box, plug in memory, graphics card, CPU, such as testing, if the computer can show the, then install the motherboard to the chassis test, until you find the cause of the problem. If the fault remains, the motherboard will need to be repaired by the manufacturer. Step 8: computer display but have alarm, w