硬盘安装步步通（国外英文资料）.docVIP

硬盘安装步步通（国外英文资料） Pre-installation considerations Before starting to install the hard disk, we first need to think clear, want to use the new hard disk to achieve what purpose and how to deal with problems such as hard disk to save data. In general, there are three main ways to install a new drive, and we can choose the best approach based on our actual needs. The installation of the new hard drive is as follows: Keep the original hard drive and use the new hard drive as a side dish; Copy the data stored in the original hard drive, and use the original hard disk as a secondary disk. Copy the data saved in the original hard disk and no longer use the original hard drive. The above three kinds of different methods will ultimately affect the actual installation process of hard disk, so wed better to ask why you install a new hard drive, is in order to obtain more storage or because there was a problem in the existing hard disk can not continue to use? If its because of the former, then we can use the new hard drive as a vice. If it is because of the latter, we need to use the new hard drive as a system master disk, and we need to back up the data from the original hard disk. How do I jump the IDE hard drive? Before we actually open the chassis to install the hard disk, should first set up hard drive jumper, if found that need to be changed until the installed hard drive jumper setting, except to remove the hard drive is no it. Its really annoying to believe that many readers have had a type of experience. The jump lines on how to set the main disk and the vice plate are clearly marked on the hard disk. An IDE slot can support both a primary and a side disk at the same time, and most motherboards currently provide two IDE slots at the same time. If we dont want to change the existing startup system, can set the new hard drive to deputy plate, at the same time, it is important to ensure that the current hard disk has been correctly set to the disc system. The manufacturer