维修电源需要修改电路中的元件（国外英文资料）.docVIP

维修电源需要修改电路中的元件（国外英文资料） Modifying the circuit can replace the switch tube of the auxiliary power supply, 2N60 and C5027. And of course the substitution is, Modify the corresponding circuit to meet the requirements of the device. Before modification, the power supply was all triode. V, Q - z# @ + d [ a; \ 5 v, in relative terms, its relatively easy to replace triode with a field effect tube, Some elements need to be removed and the parameters of the component parts of the oscillation circuit are modified to increase the protection of the stabilizer. The triode replacement field effect tube is not realistic, the work frequency can not keep up, and the second circuit is more complicated, More devices need to be added, and how to install it on the circuit board is also a problem. This approach is not recommended. 1 H/S5 l6 B (V E g I have a dozen of the less good BUZ91A, although not on other machines that use the BUZ91A, But its perfectly fine to install on a small power switch. So far, Ive modified three DVD power boards using this effect tube, A power box for a mobile hard drive, a part of a century star power supply. I understand. I want to modify the circuit The leakage voltage of the transformer 9014, can replace with C1815 8050 NPN high frequency amplifier 40 v 1.5 A 1 W 100 MHZ 8550 PNP 40 v 1.5 A 1 W high frequency amplifier 100 mhza1015pnp gm 60 v 0.1 A 0.4 W 8 MHZ (no C1015) 9014 NPN low noise amplifier 50 v 0.1 A 0.1 W 150 HMZ C1815 NPN 50 v 0.15 A 0.15 W 80 MHZ Switch tube (triode) of switch power supply, the negative electrode of 300V large filter capacitor is measured when measured, C pole voltage is 300V, B pole voltage is 0.1-0.3 V, E pole voltage is 0V. VCBO - the base of the ground, the emitter is open to the ground, the highest pressure under the specified conditions between the collector and the base pole Vebo-base grounding, the collector to the ground, the highest voltage under the specified conditions between the emitter and the base pole VCEO -