获取远程主机MAC地址的新思路及实现（国外英文资料）.docVIP

获取远程主机MAC地址的新思路及实现（国外英文资料） Get new ideas and implementations for remote host MAC addresses [date: 2006-06-10] source: [font: large medium small] Abstract: this paper analyzes the SendARP method (based on ARP protocol) is used to obtain the remote host MAC address defects, this paper proposes a new way of thinking, study and use the NetBIOS Name Service method to quickly get to the remote host MAC address, and gives its in Borland Delphi6 in the program. Keywords: MAC address, remote host, NetBIOS, TNMUDP quote As we all know, the most important thing in all network card information is the MAC address of the network card, the physical address of the network card. The MAC address is solidified in the ROM of the network card, which is not easily changed. So the best way to monitor a computer in the network is to get its MAC address. So, how do you get the MAC address for Remote Host (the Host that is not in the same subnet as the local Host)? General information: the SendARP IpHelperAPI method, but on the basis of the experimental observations, this method doesnt work - it will only get within this period of the host MAC address, if the source host and the destination host is not within the same network segment, then the method can only obtain the MAC address of the gateway, but unable to get the destination MAC address. This is determined by how the ARP protocol works. Obtain the principle and analysis of the remote host MAC address Below are the ideas and implementation methods for accessing the Remote host MAC address using the NetBIOS protocol. As you all know, NetBIOS (the network basic input/output system) is a set of call interfaces for network communication, including information such as NetBIOS Name and MAC address. The NetBIOS does not restrict the protocols that are used below, so it can run under other protocols, as well as being able to run on NetBEUI support. NetBIOS Over IP enables NetBIOS communication between remote hosts to be implemented better beca