软盘驱动器常见故障分析及处理（国外英文资料）.docVIP

软盘驱动器常见故障分析及处理（国外英文资料） Common failure analysis and processing of floppy disk drives All the Kings of guangxi The 1995-12-22 Generally speaking, the failure of the main engine is the fault that occurs when the main engine is self-checked, and when the host reads and writes the floppy disk. One, self-check failure The failure of the self-check is shown in the case of 601-diskette Error. There are two cases, one is the maladaptive card error; The second is the error of the floppy drive itself. This article only discusses the latter case. The soft drive self-check fault is mostly the control circuit of the floppy drive and the fault of the head positioning. The selected disk control circuit is the total control circuit of the floppy disk, which determines whether the floppy drive is online or offline. In the IBM PC/AT microcomputer, the option of a floppy drive is to use a cross-adapter manual, which is located between the selected disk interface connector and the selected disk control interface. If the straddle location is not properly installed, the selected disk signal from the floppy adapter cannot be sent into the floppy drive, causing the selected disk to fail. At this time, not only the floppy drive not the action, not online, its panel indicator light is not bright; 2 it is to adopt flat twist joint type control/data/state interface cable is connected to A floppy disk adapter, twist and line socket of the floppy disk is defined as A drive, the other is defined as the B drive. If the interface of the corresponding B drive is wrongly attached to the A drive, and the interface of the corresponding A drive is suspended or in contact with bad, it will also cause the disk failure. When malfunction appears self-checking, therefore, should first check whether the cable connector is well connected, A, B drive corresponding cable interface is correct, otherwise should be suspected selected disk fault or head positioning control circuit interface. Magnetic head positionin