隔离式与非隔离式的区别（国外英文资料）.docVIP

隔离式与非隔离式的区别（国外英文资料）The difference between isolation and non-isolation:Its a transformer thats waiting for the current, but its isolated from the grid, so it gets its name, you can buy it, you can make it yourself. Is the isolation voltage regulator and the non-isolation voltage regulator, is the isolation voltage regulator connected to the linear power source and the switch power supply? Is actually a special transformer, but its function is not pressure, because of his two turns of coil and wire diameter are exactly the same, so that we can have the effect of isolation and power grid, by using the function of the induced current of transformer, for the sake of safety, with the same input and output voltage (220 v), and output to the input completely isolated transformer (output banned grounding), will open the equipment from mains electricity device, is isolated power supply Isolated with the difference lies in the isolation voltage regulator input circuit and output circuit is not total, rather than in isolation type is the total. In general, there is an inductor winding between the original and the side, but only a single inductance is separated from the other. In high power and the ground wire interference protection requirements is higher when using isolation type, the volume is simpler and requiring more tension using the isolation type. Linear power supply if (they) refers to the linear output adjustment module, then the linear module must be isolation type, so the power chip is isolation voltage regulator has nothing to do with linear power supplies and switching power supply. Isolation and the isolation is the classification of the switching power supply of the two big Isolated with the difference lies in the isolation voltage regulator input circuit and output circuit is not total, rather than in isolation type is the total. In general, there are inductors of the original and the side of the non-sequestration, whereas the isolation only has a single induct