实际操作中减小电气设备接触电阻的方法!(国外英文资料).docVIP

实际操作中减小电气设备接触电阻的方法!(国外英文资料) Method for reducing contact resistance of electrical equipment in actual operation 1, overview Power network is composed of several electrical equipment, which leads to the interconnection of electrical equipment. Affected by many factors, in the surface of electrical equipment at their contact points covered with thin film material to form a layer of film by gas, oxide and sulfide or contact material and the surrounding medium after the reaction product of these substances is also belongs to the conductor, but its conductive performance is poor. If not effectively remove the influence of these substances, there exist contact resistance in the device is connected, if the contact resistance is beyond a certain value, it will seriously reduce the current carrying capacity of the equipment, but also in the electrical equipment at the junction of thermal effect is not allowed, until the production of obstacles and accidents. It is one of the permanent tasks of the electric power production department to effectively reduce the contact resistance of the power equipment connection and make it operate under controllable and controlled conditions. The mechanism of electrical equipment and a method for reducing the contact resistance of the contact resistance is as follows, please peer correction. 2. The existence mechanism of contact resistance of electrical equipment Due to the limitation of operating conditions, the electrical equipment is often exposed to air, and the electrochemical effect caused by oxidation and air pollution is the key factor to increase the contact resistance of the equipment. Connect the electrical equipment with copper, aluminum and other metal materials, the oxide resistance than itself hundreds of times, experiments show that in 40*40mm pure aluminum contact surface, if there are 50 thick alumina films in contact with enough pressure, the film has been in the critical state of deformation, contact resistance to thousan