家庭装修水电布置规范贴(国外英文资料).doc

家庭装修水电布置规范贴(国外英文资料) I. drainage works Water supply and drainage works include pipe fittings and all kinds of faucets, angle valves, fittings for water supply, indoor drainage works, etc.. Basic requirement: 1, approach must first test the horizontal line, check whether the original water pipe is unblocked; 2, the original lead-in power (meter capacity, in line with the size), telephone line, broadband information network can adjust; 3, on-site check home appliances, lamps, switches and sanitary ware location and drawings are consistent or missing, if inconsistent with the actual situation should be adjusted; 4, in addition to the design specified, hot and cold water pipes are used steel tubes, unified with 20mm supervisor, in charge with 16mm; before installation should check whether pipeline unimpeded; 5, shall not arbitrarily change the drainage pipe, floor drain and toilet and other waste, sewage drainage nature and location. Except for special conditions, the drain pipe must have a little water storage to prevent odor from being placed on the line; 6, all steel pipes connected by screws, and flax, thick paint or raw materials with lining, piping acceptance shall comply with the =0.6Mpa pressure regulator; 20 minute tube pressure decreased as the standard of =0.5Mpa; sewer pipe after completion of all temporary sealing, to prevent blocking chores; 7, the installation of the pipeline should be horizontal, vertical, laying solid, PVC down the water pipe must be glued tight, slope meets the requirements of 35/1000; 8, pipe installation shall not be close to the power supply, and in the wire pipe below, cross need to bridge over bend, water pipe and gas pipe spacing should be not less than 50mm; 9, leading to the balcony of the water pipes must be fitted with valves, as far as possible to avoid joint; 10. The distance between hot and cold pipes shall be determined according to the actual size of the taps. The two leaders (with the head of the heart must galvanized pi