建筑基础知识(国外英文资料).docVIP

建筑基础知识(国外英文资料) But the frame beam has different requirements for the diameter and spacing of stirrups according to the different seismic grade, not only to meet the calculation requirements, but also to meet the structural requirements. (4) In the plane representation, the frame beam is numbered KL, and the secondary beam is numbered L. In the actual construction drawing, there are two main kinds of mistakes that designers easily make. First, in the flat method of the secondary beam, the stirrups are expressed by the encrypted area and the non encrypted area, such as phi 8#100/200 and so on. The two is when the secondary beam is simply supported beam, the number of negative reinforcement support often do not meet the provisions of article 10.2.6 of the concrete standard (article 10.2.6 when the actual beam end by some constraints but by simply supported, should be set in the longitudinal structure of steel, bearing the upper region of the cross section area should not be less than the cross beam in the lower part of the longitudinal reinforcement calculation of the required cross-sectional area should not be less than 1/4, and two). What are the differences between the foundation beam and the secondary beam? The fundamental beam refers to both ends and caps or single column connected beams and secondary beams, the same lies in the fundamental beam is no seismic requirements, the fundamental beam beam roof reinforcement in the anchorage length of the bearings for the tensile anchorage length of La, the fundamental beam stirrup is not encrypted and non encrypted area request. And the difference lies in the fundamental beam beam beam bottom reinforcement tensile anchorage length must also meet La requirements, the fundamental beam width should not be less than 250mm, in addition to the calculation of the fundamental beam in the beam under the external requirement of longitudinal reinforcement diameter should not be less than 12mm and not less than 2 (article 8.5.20 see