数车工技术(国外英文资料).docVIP

数车工技术(国外英文资料) FSF sewing technology 1 DFD high speed turning slender shaft should pay attention to the problem If the car pole lathe. This sentence reflects the difficulty of driving a slender pole. Because of the characteristics of slender shafts and technical requirements, vibration, multi edges, slub, cylindricity difference and bending are easy to occur in high speed turning. If you want to drive it well, you must pay attention to the problems in the process. (dfd1) machine tool adjustment. The connection between the two center line of lathe spindle and tailstock is parallel to the top, bottom and left of the lathe big guide rail. The tolerance should be less than 0.02mm. (2) workpiece installation. When installing, try not to produce any positioning. Do not exceed 10mm by clamping the end of the cartridge. (3) cutting tools. The kappa r=75 degrees to 90 degrees partial knife, attention to the side angle after 0 less than or equal to 4 degrees to 6 degrees, do not. The tool should be slightly higher than the center when installing. (4) with the dressing tool, after installation must be dressing method, can be used to research, reaming, boring and other methods, the R arc radius of workpiece contact with the knife claw and the workpiece, must not be less than the radius of workpiece, to prevent multiple. When adjusting the handle of the tool post, contact the claw with the workpiece, and dont force it to prevent the slub from producing. (5) auxiliary support. When the length diameter ratio of the workpiece is greater than 40, additional support shall be adde