旋翼机(国外英文资料).docVIP

旋翼机(国外英文资料) Meet the requirements of heavy helicopters; 2, the rotor shaft tilt installation, how to avoid the rotor is too close to the ground; 3, how to improve the speed of flight, reaching 300 kilometers per hour. 1. Increase the number of blades of the rotor: the rotor of the cross rotor is tilted, and the left and right rotors cross in space to avoid collisions. When the number of blades increases to 3, the rotor can be distributed about 120 degrees. The rotor has potential collision problems, and it is possible to avoid collisions by coordinating the relationship between the left and right rotors. When each blade is increased to 4 pieces, and the 4 rotors are distributed at 90 degrees, the spatial cross distances of the left and right rotor blades are shortened, and the cross part is far from the axis, and the blade deformation is large, and the collision is easy to cause collision. In order to avoid collision, we should adjust the angle between each rotor blade. When the 4 blades are deployed according to 45 degrees and 135 degrees, the space intersection point will be close to the rotating shaft, so that the distance will be increased so as to avoid collision. In addition, when the cross rotor is used in heavy helicopters, the rotating shaft increases in distance, and also helps to increase the space distance of the rotor and avoid collisions. 2, the rotor blade is slightly closer to the ground. When the rotor rotates, it forms an inverted cone under the influence of centrifugal force and lift force. The angle between the cone and the horizontal plane is the cone angle. Usually the cone angle is 3-5 degrees. In order to prevent the rotor blades from colliding slightly on the ground, the rotor is designed to be mounted at 5 degrees cone angle to increase the distance of the rotor slightly from the ground. 3. How to increase the speed of the flight? Obviously, the rotor area of the cross rotor is large, and the speed of the flight can not be increased simply