柴油机5(国外英文资料).docVIP

柴油机5(国外英文资料) C 401. on the structure of cylinder sleeves, the correct one is (). A. cylinder liner, shoulder, radial and axial fixed B. cylinder liner and cylinder head are made of copper gasket to realize high pressure gas seal C. the lower part of the cylinder liner is not fixed axially, and there is a gap between the outer part of the cylinder and the inner hole of the cylinder The D. cylinder is bolted to the cylinder block D 402., in order to ensure the reliable operation of the upper shoulder of the cylinder liner, the measures that can be taken in the structure are (). A. combustion chamber up B. borehole cooling C. combustion chamber down D. above all D 403., in order to ensure the reliable operation of the upper shoulder of the cylinder liner, the measures that can be taken in the structure are (). A. combustion chamber up B. reduces the wall thickness of the convex shoulders C. uses a highly convex shoulder hole cooling structure D.A and C The installation status of A 404. cylinder liner is (). The upper part of the A. is fixed, and the lower part can expand freely B. bottom fixed, free expansion at the upper part C. radial fixed, axial fixed D. axial fixed, radial free expansion The scavenging port at the lower part of the cylinder liner of the C 405. two stroke diesel engine has a pitch of two vertical and horizontal directions. A. increase cylinder strength B. is good for cooling C. to improve scavenging effect D. increase intake Oil distribution tank and oiling Kong Cheng (406.) on inner surface of C cylinder liner. A. horizontal arrangement B. tilt up and down C. tilt down layout D. vertical layout The structure of the oil groove on the cylinder liner of the D 407. pass two stroke diesel engine is wrong. A. oil groove is eight shape is good B. the oil tank is shallow C. the oil tank is narrower D. the oil groove is as deep as possible 408. C two stroke bending flow scavenging diesel cooling water leakage detecting hole on the cylinder body, its positi