水电安装工程监理实施细则(国外英文资料).docVIP

水电安装工程监理实施细则(国外英文资料) Electrical engineering I. strictly control raw material quality 1. the type, specifications and strength of the material shall comply with the design requirements. 2. when the material enters the factory, the factory must have the certificate of qualification, and the supervisor shall take samples and check the samples. 3. iron pipe approach, you must rust, brush anti rust paint after use. Two. Construction quality control point 1. piping should be layered and segmented, a check, the location, size, height, camber, joint, Guan He, fixed orifice treatment compliance. Two Earthing pole laying, lightning protection lead line and lightning protection belt shall check whether the welding, corrosion prevention and laying are in accordance with the standards and keep a record. The use of structural reinforcement made of lightning lead wire, the structure of steel continuous compliance with specifications and requirements, specifications section is correct. 3. the color, insulation and installation of the wires meet the requirements. 4. the installation of electrical equipment should pay attention to the model, elevation and location, whether it meets the requirements of the drawings, wiring methods are in line with specifications. Three. Construction quality requirements 1. installation quality control of distribution box According to the code for construction and acceptance of electrical lighting installations for electrical installations, GB50259 - 96 (1) The inlet pipe hole of the distribution box shall be a pressing hole, and the inlet pipe shall be introduced from the hole with proper specifications and arranged in a straight line. The length of the inlet and the trunk shall be provided with the locking nut, and the remaining 2-4 buckles shall be provided with a retaining cap. Prohibit the use of welding and welding cutting holes, the box deformation caused by heat. (2) the wires in the distribution box must be firmly connected and bundled into bu