基于si4432的温湿度采集电路设计与实现本科论文.docVIP

信息工程学院本科毕业论文 （2013届） 题 目 基于Si4432的温湿度采集电路设计与实现 系 电子工程 专 业 电子信息科学与技术 班 级 学 号 学生姓名 王超超 指导教师 孔庆鹏 完成日期 2012年12月 诚 信 承 诺 我谨在此承诺：本人所写的毕业论文《高灵敏度授时信号接收系统》均系本人独立完成，没有抄袭行为，凡涉及其他作者的观点和材料，均作了注释，若有不实，后果由本人承担。 承诺人（签名）： 年 月 日 摘 要 温湿度的自动测量和显示记录是工厂的一项常规监测项目。以往的人工采集数据占用人力资源，可靠性低，容易发生差错已经不适应工业化生产的要求了。一般的温湿度采集系统数据显示单调，缺乏支持各种PLC的通讯端口，而且温湿度采集模块布线繁琐且受原有车间布局的约束。 本文采用目前应用广泛的ARM系列微处理器ATMEGA48作为平台的核心构建系统。发射板：温湿度采集器以ATMEGA88作为主控制芯片，采用数字温湿度传感器芯片SHTl0采集外界温湿度值。然后通过无线射频收发器SI4432将数据发送到发射板。接收板：以ATMEGA88作为主控制芯片使无线射频收发器SI4432所接收到的温湿度的数据显示在LCD1602显示屏上，省去了冗长且铺设不便的通讯电缆。 本项目的硬件设计任务包括：设计目标，主机以及温湿度采集模块的器件选型以及原理图设计，PCB板的设计指示，测试以及调试。 关键词：；；；ABSTRACT The automatic-measure and the records display of temperature and humidity is one of the conventional monitoring projects in the factory. In the past, people collected data themselves. In this way, it needed much human resource with low reliability. Of course error is easy to happen. So this way was not fit to the requirements of industrial production. General temperature and humidity collection system display data monotonous and short of history data. Many of these systems also don’t support the communication with most of PLC. Furthermore, temperature and humidity collection module is difficult to layout as too many lines．It is restricted by the placement of plant also． This paper utilizes ARM micro-processor‘ATMEGA48’as the core ofthe platform to buildup system, which is applied widely at present.Transmitter board: temperature and humidity logger ATMEGA88 as the main control chip, digital temperature and humidity the sensor chip SHTl0 acquisition outside temperature and humidity valu?ed. Then through the radio frequency transceiver SI4432 data will be sent to launch plate. Receiving plate: ATMEGA88 the wireless RF transceiver as the primary control chip SI4432 received by the temperature and humidity data LCD1602 display, eliminating the a lengthy and layi