如何清除系统密码u大师u盘启动盘制作工具告诉你.doc

如何清除系统密码u大师u盘启动盘制作工具告诉你 好郁闷，记性不好，又忘记电脑的登陆密码了，这可怎么办呀，难道重装一次系统，太麻烦了吧！u大师u盘启动盘制作工具果断的告诉你:NO！不需要重装，我们有更好的办法，只要按照下面的步骤来操作，一下就能解决你的烦恼！ 第一步：准备u盘一个、及下载u大师u盘启动盘制作工具，并制作成启动u盘 第二步：将制作好的启动u盘插如电脑，进入安装界面后选择【10】 第三步：如果想清除原系统登录密码，选择【01】，如图： 输入1，回车，如图： 自动搜索所选分区存在的所有SAN，根据自己的需求选择一个，按ENTER键，如图： 选择设置了密码的账户，回车，如图： 根据自己的需要，通过空格键更改各个属性，然后按下Y保存退出，如图： 再次开机时，不用输入密码也可以进入系统了。 如果你想清除设置的登录密码，那么在第二个选择界面时选择【02】，密码会被自动清除，下次登录时，就可以不用输入密码即可登录系统，如图： the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest t