装winpe工具箱的u大师u盘启动盘制作工具.doc

装win03pe工具箱的u大师u盘启动盘制作工具 什么是win3pe工具箱了，其实就是win7系统的风格的xp系统哦，那么该何如操作win3pe工具箱吗？不急不急，现在小编就慢慢的告诉大家： 第一步：下载 进入官网，可以分别在首页、下载中心下载新版u大师u盘启动盘制作工具 第二步：安装 第一点：双击上步中下载好的U大师U盘启动盘制作工具的安装文件“udashi_Win3_2.0”，运行安装程序。 第二点：单击界面上的“安装”按钮，开始工具的安装，如图： 第三点：安装完成后，在电脑桌面上就会显示“U大师装系统Win3工具箱”快捷方式，并自动运行工具。 第三步：制作 第一点：双击运行电脑桌面上“U大师装系统Win3工具箱”的快捷方式。 第二点：该工具能够自动识别出插入电脑USB接口的所有USB设备，请选择要制作成启动U盘的盘符，然后可以根据个人情况，分别设置启动模式和系统格式，如图： 第三点：设置完成后，即可单击“一键制作”按钮开始启动U盘的制作，如图：   第四点：成功制作完成后，会弹出一个新窗口，用户可以根据窗口中的提示，进行相应的操作，也可以直接忽略，如图： 第五点：退出制作工具，打开U盘，可以在U盘根目录下，看到几个重要的文件夹，如图：  the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of