TopicsofPresentation分析.pptVIP

Topics of Presentation Overview of Turbine Concept of Governing System Functioning of EHC Circuits Turbine Start Up Procedure TSI TSC System Turbine Protection System Turbine Block Diagram Turbine Components Turbine: HPT, IPT, LPT1 and LPT2 Turbine Bearings: 08 Generator / Exciter Bearings: 04 Turbine Stop Valves: 04 (HPSV-12, IPSV-12) Turbine Control Valves: 08 (4 HPCV 4 IPCV) CRH Check Valves: 02 ( With Bypass lines for warm up) Motor driven Shut Off valve in non-stabilized oil line to Check Valve Motor driven warm up Shut Off valves for HPCV-3 4 Governing Box Overview of Governing Box Governing Box Components Motor operated Control Gear to generate resetting / protection oil control oil for S.V./ Summators Two Manual trip devices Two Over Speed Governor Slide valves (110 % 111 %) Two Remote Trip Solenoids Slide Valve for ATT with two solenoids Governing System Combination of throttle nozzle governing IP Turbine has throttle governing – all four control valves open simultaneously HP Turbine has nozzle governing – all four control valves open in preset sequence Resetting of Turbine is done by Control Gear operation Operation of Stop Control Valves and CRH Check Valves are done by spring type hydraulic servomotors Servomotors are closed by spring action during loss of oil pressure Governing System HPT control valves open only after achieving preset load (12% of 660 MW) Opening time of control valve is 1.5 sec Closing time of Stop valve in case of operation of protection is 0.3 sec Turbine maximum speed is restricted to 108% in case of generator disconnected from grid Over speed protection system stops steam supply in HPC in 0.5s Speed Controller Droop is adjustable from 2.5% to 8% (with dead band of 0.04%) Resetting of Turbine Resetting of Turbine Stabilized oil pressure of 50 Ksc is supplied to Control Gear The control gear (AE001) is moved from closed position (0 degree) to open position (90 deg) Oil is first supplied to r