室内消火栓安装(国外英文资料).doc

室内消火栓安装(国外英文资料) Plan for the installation of the internal fire hydrant system 1 scope This process is suitable for the installation of the indoor hydrant pipe system in civil and general industrial buildings. 2 construction preparation 2.1 main ingredients: 2.1.1 fire hydrant system pipe should be selected according to the design requirements, generally USES the carbon steel pipe or seamless steel tube, tubing shall not be bent, rust, double skin and concave and convex inequality. The type of type 2.1.2 hydrant box shall conform to the design requirement, the cabinet surface is flat and clean. The metal case is not corroded, cut, the door is open and flexible. The box is square and all parts are well. The valve exterior rules, no crack, open and close, close tightly, the sealing packing is in good condition, and the products are well certified. 2.2 main machine tools: a silk machine, grinding wheel saw, bench drill, electric hammer, hand grinding wheel, hand electric drill, electric welding machine, electric test pump and so on. Silk board, tube pliers, vice, pressure pliers, chain tongs, handhammer, hacksaw, wrench, nail gun, reverse chain, electric welding and other tools. 2.3 working conditions: Construction drawings and relevant technical documents shall be complete, and the on-site water, electricity and gas shall meet the continuous construction requirements, and the system equipment materials will guarantee the normal construction. The baseline required for piping and box installation shall be determined and marked. The reservation and burial have been completed with the construction. 3 operation process 3.1 process flow: Installation preparation, dry-pipe installation, box and branch installation, box parts installation, water debugging 3.2 installation preparation: 3.2.1 seriously familiar with drawings, combined the situation whether review coordinates and elevation of the pipe position properly, if there are any problems, promptly with the designer on th