挖掘机机油压力低的故障原因分析(国外英文资料).docVIP

挖掘机机油压力低的故障原因分析(国外英文资料) Analysis of the cause of failure of excavator oil pressure The 2009-4-8 An excavator is working on oil suddenly appeared the fault alarm, dashboard driver immediately stop for inspection, oil through the oil oil dipstick check oil level, viscosity is normal? Is it normal to remove the oil filter to check the filter core? Results more than two works, because there is no suitable detection tools, unable to further check, customer hope we can help them to make further checks to troubleshoot, mechanical returned to normal use. What causes engine oil pressure anomalies in the engine process? We first do a detailed analysis of the causes. Diesel engine lubrication system is mainly composed of the oil pan, oil pump, oil filters, radiators, oil, points out of the main oil and low oil pressure alarm sensor, oil high oil temperature alarm sensor, pressure limiting valve with a bypass valve. There are several reasons why oil pressure is low: The oil is not enough Oil if the oil is insufficient, will reduce oil pump pump oil or by entering the air pump oil, the oil pressure drop, the crankshaft and bearing, cylinder liner and piston will aggravate wear due to bad lubrication. Therefore, it is necessary to check the oil level in the oil bottom shell before working every day to ensure that the oil level is normal and should be added to the same type of oil from the same manufacturer. No transfer of oil pump If the driving gear of the pump is damaged or shed by the flat key of the drive shaft; The oil pump is sucked into the oil pump and the gear is jammed, and the oil pump is stopped and the oil pressure is reduced to zero. The damaged flat key or set filter should be replaced at this time. Machine oil pump wear Oil pump pump clearance between shaft and bushing, the gear end face and the clearance between the pump cover due to abrasion, backlash, or radial clearance is too large, will lead to pump oil decreases, and makes oil pressure drops. The worn part