电磁炉电路板简单维修方法,错过后悔!(国外英文资料).docVIP

电磁炉电路板简单维修方法,错过后悔!(国外英文资料) Electromagnet circuit board simple maintenance method, missing regret! Maintenance method, electromagnet circuit board, circuit board maintenance, circuit board 1. Repair the induction cooker afraid of IGBT tube burning trick Replace the IGBT remember to replace the drive tube together at the same time (good or bad; a lot of people dont have the bad cant measurement in; the price is again soon burn IGBT; two triode up to 1 yuan; a IGBT is about to turn a dozen) also check under 0.2 UF0.3 UF5UF capacitance; Ready. (2) on the ac 220 v, connect a 60-100 w bulb, pan, switched on: (1). If the bulb is dark red (applicable to plug in a 220 v after the standby indicator), open the induction cooker, a bright a light bulb, after 220 v (and inserted in the standby indicator light is not bright), open the induction cooker, a light bulb is dark to restart the power supply is also a bright or dark; It shows that the induction furnace is basically OK. (2). If the light bulb is bright, the IGBT tube is fully conductive. At this point, if the light bulb is removed, IGBT will be burned! The circuit should be mainly used to drive the high voltage rectifier of resonant capacitor. (3) if the light bulb is dark red, turn on the electric power of the electromagnetic furnace, the bulb brightness is not changed. The main inspection panel should be used to control microcomputer power supply and other circuits. (4) if the light bulb is dark red, turn on the electric power of the electromagnet, the bulb flicker in a flash, but the light bulb is very bright; To raise IGBT, check the CPU drive line. Simple maintenance of electromagnet circuit circuit board A, circuit board burn IGBT fuses the maintenance program of current fuse or IGBT burn out, not immediately change the parts, must confirm the following other parts are in normal state can be replaced, otherwise, the IGBT and the fuse will blow out again. See if the current fuse is broken Check if IGBT is wearing: Me