轻型树脂传递模塑工艺(L-RTM)(国外英文资料).docVIP

轻型树脂传递模塑工艺(L-RTM)(国外英文资料) Lightweight resin transfer molding process (l-rtm) - a rapidly developing low-cost manufacturing technology L-rtm process introduction Traditional RTM process, because it is closing process, has a less volatile organic compounds (VOC) emissions (below of SPPm), expand the scope of available raw materials, lower labor and environmental friendly as well as the advantages of both sides can get bright and clean products. But in the RTM process, resin injection is under high pressure and velocity, so we want to make the mould structure strength and stiffness big enough not to undermine, deformation under the injection pressure. Usually used for steel pipe support of sandwich composite materials, or use the aluminum mold or die on CNC machining, the manufacturing cost increase, only large enough products to yield, to offset the mould cost. In addition, to close the mold, there are enough clamper and the pressure system to close the mold. All of these factors limit the use of RTM technology on big products, or the mold will become heavy and investment will be large. Light resin transfer molding process (RTM one Light) is also known as LRTM, ECO, Vacuum Molding or VARTM. It is a rapid development of low cost manufacturing process in recent years, and has already applied more than RTM technology in ships, automobile, industrial and medical composite materials. The RTM Light process retains the RTM process and retains almost all the advantages of the RTM process. But the upper die for semi-rigid steel, glass thickness is usually 6 to 8 mm, usually do not need to use steel reinforcement, the mold has a rigid around about 100 mm wide, made an independent double sealing tape sealing area, as long as a vacuum mold is closed, it is convenient, fast. Then vacuum inside the cavity, the use of negative pressure in the mould and lower injection pressure will be resin injection mold, the resin infiltration of reinforcing fiber are laid in advance or fabricatio