通用变频器的保护功能及故障处理(国外英文资料).docVIP

通用变频器的保护功能及故障处理(国外英文资料) 1 the introduction The frequency converter itself has quite a lot of abnormal fault display and protection function. If the protection actions, frequency converter tripping immediately, LED display the fault code, or the fault information is stored in the application of a certain parameter, to stop the motor in the free running state. The tripping status is maintained until the failure cause is cleared, the TESET key or control circuit terminal RST input is reset, so that the inspection is maintained. Abnormal frequency converter fault divided into two categories: failure of soft and hard, more than the former because of improper operation or parameter Settings, hard fault is caused by frequency converter device itself damage, repair work can be very inconvenient. Processing before failure should pay attention to check before failure frequency converter running records, mainly including electric current, rotational speed, winding and bearing temperature etc., so that the fault analysis and inspection. When the inverter show certain problems, but without corresponding fault occurring in the process of troubleshooting, at this time should be carefully check fault detection components or fault information processing system with and without problems. Fault inspection or maintenance, attention must be cut off power supply, frequency converter input transformer into high voltage circuit breaker rock out of the line side, and the inverter A1, A2 GuiZhu switch into line, and need 8 min power capacitor discharge has been completed, can open cupboard door maintenance, avoid by all means stop immediately after inspection. For rated frequency converter running, the dc bus voltage can be up to 1000 v, and filter the number of electrolytic capacitor used for 120, a single capacity of 6800 mu, F to store huge amounts of electricity, after downtime must be capacitor voltage balance in front of the module, resistance to discharge voltage is reduced (the disc