齿轮噪音原因分析(国外英文资料).docVIP

齿轮噪音原因分析(国外英文资料)Cause and control of gear noiseThe noise of gears is a problem that people have long been concerned about. But people have not fully solved the problem because there is only a small amount of vibration energy in the gears that can produce sound waves making noise. Noise affects not only the surrounding environment, but also the machining accuracy of machine tool equipment. Because the vibration of gears directly influences the machining precision of the equipment, it can not meet the requirement of production technology. Therefore, how to solve the noise of gearbox gears is especially important. Here are some simple ways to eliminate gear noise in mechanical equipment design and repair.The cause of noiseThe effect of 1.1 RPMIf the gear drive is higher, the vibration frequency of the gears increases, the robed shocks are more frequent and the high frequency wave is higher. According to the relevant information, the speed of revolution at 1400 revolutions per minute has a frequency of 5000H. The resulting sound waves are as loud as 88dB. The speed of the output shaft of a normal optical equipment is higher. As high as 2000 ~ 2,800 RPM. Therefore, it is necessary for optical equipment to solve the noise problem.Impact of 1.2 loadsWe use gear as a vibrating spring system, as a vibration system of mass. Then the system is affected by different impact load, and the rotation of the gear is turned to turn the vibration in a circular direction. The noise of the periodic amplitude is generated by the difference in the stiffness of the gears. This noise is smooth without screaming.The effect of 1.3 tooth errorThe tooth shape error is sensitive to the vibration and noise of gears. The tooth curve of the gear deviates from the standard involute form, and the error of the length of the common normal line increases. At the same time, the deviation of the tooth shape error causes the top and the root of the tooth to interfere with each other.The impact of the 1.4 re