监理工作程图.doc

不同意 同意 不同意 同意 是 否 是 否 工程进度控制监理工作程序图 不同意 同意 一般工程进度计划的编制程序 未通过 通过 未通过 通过 施工阶段进度控制流程图 未通过 通过 施工进度计划的审批程序图 是 否 否 是 索赔程序流程图 有 有 无 是 否 工程投资控制方法示意图 未通过 通过 未通过 通过 通过 未通过 质量控制流程图 政策法规 条例规范 合同条件 建设单位 建设单位 施工单位 建材市场 政府有关部门 其 他 金融机构等 施工单位等 监理信息处理示意图 工程合同管理系统功能示意图 行政事务管理系统功能示意图 不同意 同意 不同意 同意 否 是 是 否 监理人管理变更工作程序图 常用监理工作程序图 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is