幸免空中砖空鼓的办法(国外英语资料).docVIP

防止地面砖空鼓的措施(国外英语资料) 1, the grassroots must be seriously cleaned, and fully wet irrigation, wet time is generally 24h, and no water phenomenon, in order to ensure good combination of cushion and the base. 2, select the tiles, apply water more than 2h, bubble to glazed tile, suction enough water and no bubbles until the surface drying before use, in order to ensure that it has a good paste with mortar. 3, in the wet grass-roots brush cement paste, plain cement slurry should be stirred evenly, besmear evenly. It is strictly prohibited to sprinkle the cement surface before sprinkling and sweeping. Because of this method, cement mixing is uneven and water cement ratio can not be controlled, which will affect the bonding effect. 4, 1:2 dry cement mortar cushion, should brush and cement paste together with the brush with PU, and wood trowel rub flat, uniform thickness, the thickness is 15mm, not a mortar shop too thick, in case the tiles are placed on the bottom after the mortar is not easy to cause local compaction. Hollowing. 5, test paving process, such as the discovery of a cushion thickness or uneven, should uncover tiles, add or remove excess mortar, with a rubber hammer solid brick, the tile surface is lower than the design elevation of about 5mm. 6, the opening of the shop brick, and its back evenly coated layer, with strength grade 32.5 ordinary portland cement mortar, the thickness is about 5mm. Plastering, tile slightly thicker in the center of the round, cement mortar should be put into the edge of 10mm wide slope. 7, after the brick plastered flat on the cushion, hands slightly harder push, then use a rubber hammer tapping, and make the base firmly bonded with a rubber hammer percussion, such as sounds found in the lack of slurry, should expose below Tim brick, cement mortar with paste. 8, brick paved after 24h, should be sprinkler maintenance 1~2 times, in order to supplement the cement mortar in the process of hardening of the water, ensure the brick and mor