无梁楼盖(国外英语资料).docVIP

无梁楼盖(国外英语资料) Flat slab floors are more useful in garages and shopping malls, especially in non seismic areas. Now lets talk about the design of the slab without beam: Design： About the calculation of the internal force of the beam free board, the general software is not very good, and PKPM put forward the relevant calculation method, I think it is not very perfect, it only refers to the displacement, cycle calculation. For the construction drawing design is not perfect. The computer calculation method is the finite element analysis method. In general, hand counting methods include equal frame method and empirical coefficient method. The equivalent frame is put into the corresponding plate with equivalent stiffness of beam and column, then combined into frame in the calculation, this level should pay attention to in the calculation of the equivalent frame board width, calculation of structural displacement and cycle are useful, but there is one point to note that the column stiffness is not accurate. If you have to wait for two generation more trouble. PKPM mentioned that using elastic plates and real columns, I think they should be accurate. I have compared the bending moment without horizontal force, basically no change. If the condition of the empirical coefficient method is used, the empirical coefficient method is very simple and the calculation is more accurate. The empirical coefficient method is to define the internal forces of the side span according to the cross span condition, and the inner span is used to distribute the internal forces with 0.65Mo and 0.35Mo. Therefore, first of all, the midspan bending moment under the simply supported Mo must be calculated. What should pay attention to is the span of non - beam floor, calculation model and calculation load. If there are column cap and pallet, but also pay attention to the internal force will tilt to the support, at this time should pay attention to the location of the section design, and node structure